COMP Cams 913 Acura B18 Valve Spring Set User Manual
Instructions

COMP Cams®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #COMP4-104
Revised 6/28/06
#913 Acura B18 Valve Spring Set
Thank you for choosing COMP Cams® products; we are proud to be your manufacturer of choice. Please read
this instruction sheet carefully before beginning installation, and also take a moment to review the included
limited warranty information.
The COMP Cams® Acura/Honda B-Series VTEC valve spring set (Fig.
A) utilizes dual springs on the intake side and a single spring on the
exhaust side. Below are the information and diagrams to ensure correct
installation.
Installation Instructions:
Warnings and maintenance information!
It is important to orientate the outer valve spring of the intake and
exhaust (See Fig. B & C) with the *tightly wound coils on the
bottom. THE ORIENTATION OF THE INNER INTAKE SPRING
IS NOT CRITICAL.
*Note: To figure out which end is the tightly wound end start at
the end of the coil. Follow it around 180° (See Fig. D) then look
at the distance between the two coils. Now follow the same steps
from the other end of the spring. Whichever end is closest
together needs to be on the bottom.
INSTRUCTIONS
Dual Intake Spring
Installed Height: 60lbs at 1.375
Open Height: 220 lbs at .875
Coil Bind Height: .815
Spring Rate: 300 lbs per inch
Single Exhaust Spring
Installed Height: 43 lbs at 1.375
Open Height: 148 lbs at .875
Coil Bind Height: .815
Spring Rate: 210 lbs per inch
Springs shown here with tightly wound coils on bottom.