COMP Cams 6300 Hi-Tech Belt Drive Systems User Manual
Page 4
COMP Cams®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #188
Revised 3/14/08
Additional installation notes:
1. Included only in the small block kit is a 2” diameter washer and left hand thread, 7/16”, 12 pt bolt (torque to
30 ft lbs) for use with a MSD, etc. cam driven distributor. This must be installed on the drive to prevent any leaks.
2. Included only in the big block kit is an oversized belt tensioner pulley (black anodized) that can be used on
those applications where the cam-to-crank centerline distance has been reduced due to line boring the engine
block, or the belt has become stretched. Simply remove the belt tensioner bearing and assembly from the red
anodized unit, install it in the black housing, and use the black anodized idler pulley in place of the red one (fig.
11).
3. Also included only in the big block kit is a pair of water pump spacers and gaskets that must be used to
position an OEM pump for proper clearance.
4. A pilot tool included only in the big block kit, designed to facilitate installation
of the cam pulley/flange assembly, is supplied for use in dynamometer
environments, where numerous cam changes are desired (fig. 13).
5. The unit is designed for use in a paved, on-road environment. Make sure that
rocks and debris are prevented from getting into the assembly. Keep clean of dirt
and oil. It is possible to use this drive in a dirt track application, provided that a
cover is fabricated to isolate the drive from contamination by dirt and debris.
Limited Warranty
Competition Cams, Inc. warrants that all of its products are free from defects in material and workmanship, and against
excessive wear for a period of (1) one year from the date of purchase. This limited warranty shall cover the original
purchaser.
Competition Cams, Inc.’s obligation under this warranty is limited to the repair or replacement of its product. To
make a warranty claim, the part must be returned within (1) one year of purchase to the address listed below, freight prepaid.
Items covered under warranty will be returned to you freight collect.
It is the responsibility of the installer to ensure that all of the components are correct before installation. We assume
no liability for any errors made in tolerances, component selection, or installation.
There is absolutely no warranty on the following:
A) Any parts used in racing applications;
B) Any product that has been physically altered, improperly installed or maintained;
C) Any product used in improper applications, abused, or not used in conjunction with the proper parts.
There are no implied warranties of merchantability or fitness for a particular purpose. There are no warranties, which
extend beyond the description of the face hereof. Competition Cams, Inc. will not be responsible for incidental and
consequential damages, property damage or personal injury damages to the extent permitted by law. Where required by law,
implied warranties or merchantability and fitness are limited for a term of (1) one year from the date of original purchase.
This warranty gives you specific legal rights and you may also have other legal rights, which vary from state to state.