COMP Cams 3135KT Adjustable Fuel Pump Eccentric User Manual
Page 2
pump eccentric is infinitely adjustable so you can fine adjust your engine’s camshaft timing to
exactly where you want it.
7. Adjust the Camshaft Timing. Do NOT try to turn the camshaft with the eccentric unless there is
NO LOAD on the camshaft. Make sure that the camshaft bolt is LOOSE. For a simple
installation, adjust the fuel pump eccentric to the desired timing setting. For a more accurate
installation, use a degree wheel. The degree wheel method is strongly recommended.
8. Torque Loose Bolt. Apply a generous amount of thread locking compound to the camshaft
sprocket mounting bolt. torque the camshaft sprocket mounting bolt to 40-45 ft-lb.
9. Lubricate the Timing Set. Make sure that the engine oil has a clear path to the timing set through
the lifter valley oil drain-back holes, or through some other means. A timing set requires plenty of
oil to survive. Before installing the timing cover gasket and timing cover, pour plenty of assembly
lube over the sprockets and bearings. Assembly lube will stay on the sprockets until the engine is
started.
10. Install the Timing Cover and Gasket. Install the timing cover gasket using a small amount of
gasket sealer if desired. Mount the timing cover and the rest of the engine accessories according to
the manufacturer’s procedures.
Limited Warranty
Competition Cams, Inc. warrants that all of its products are free from defects in material and workmanship, and against
excessive wear for a period of (1) one year from the date of purchase. This limited warranty shall cover the original
purchaser.
Competition Cams, Inc.’s obligation under this warranty is limited to the repair or replacement of its product. To
make a warranty claim, the part must be returned within (1) one year of purchase to the address listed below, freight
prepaid. Items covered under warranty will be returned to you freight collect. It is the responsibility of the installer to
ensure that all of the components are correct before installation. We assume no liability for any errors made in
tolerances, component selection, or installation.
There is absolutely no warranty on the following:
A) Any parts used in racing applications
B) Any product that has been physically altered, improperly installed or maintained;
C) Any product used in improper applications, abused, or not used in conjunction with the proper parts.
There are no implied warranties of merchantability or fitness for a particular purpose. There are no warranties,
which extend beyond the description of the face hereof. Competition Cams, Inc. will not be responsible for incidental and
consequential damages, property damage or personal injury damages to the extent permitted by law. Where required by
law, implied warranties or merchantability and fitness are limited for a term of (1) one year from the date of original
purchase. This warranty gives you specific legal rights and you may also have other legal rights, which vary from state to
state.
Part # 150
Revised 12/6/04
Competition Cams, Inc
3406 Democrat Rd.
Memphis, TN 38118
(901)795-2400 FAX (901)366-1807
www.compcams.com