Comfort Company Flexion Footbox Double - Manual (Page 2)

FLEXION FOOTBOX ™ - DOUBLE
1
2
3
4
5
6
7
Remove center foam/cover piece.
Place the Flexion Footbox on the wheelchair footplates in the required position.
Drill 4 mounting holes through the bottom of the wheelchair footplates and through the bottom
of the Flexion Footbox plate as shown in Figure 1. Holes must be big enough for a ¼”-20 screw.
Attach the Flexion Footbox to the foot plates with screw (D or E) depending on the thickness of
the foot plates; along with the washer (F), washers (G), and nut (H) using Allen Wrench (C) as
shown in Figure 2.
Reattach the center foam/cover piece.
Remove screw (A) and washer (B) on both sides using Allen Wrench (C) as shown in Figure 2.
Adjust the angle of the Flexion Footbox to the required position as shown in Figure 3 and then
reattach screw (A) and washer (B) to lock the Flexion Footbox in place.
Parts Included:
Pre-Attached
2 - (A) Screw 1/4-20 x 1/2” Button Head
2 - (B) Washer 0.25” ID, 0.75” OD
From Kit Bag
1 - (C) Allen Wrench 5/32
4 - (D) Screw 1/4-20 x 1.25” Phillips Pan Head
4 - (E) Screw 1/4-20 x 1” Phillips Pan Head
4 - (F) Washer Internal Tooth, 5/16” ID
8 - (G) Washer 0.25” ID, 1.25” OD
4 - (H) Nut 1/4-20 Nylon Lock
D OR E
F
G
H
A
B
90 160
DRILL MOUNTING HOLES
FIGURE 1: MOUNTING HOLES
FIGURE 2: HARDWARE ATTACHMENT
FIGURE 3: ANGLE ADJUSTMENT