CLEAR Spot 4G Users Guide - Manual (Page 13)

12
Manage your CLEAR Spot (continued)
CLEAR Spot Home Page / Basic / Wizard
The Setup Wizard guides you through the basic CLEAR Spot setup steps. You can change the
administrative password, select the time zone, choose the CLEAR Spot wi-fi network name, and
choose the security type.
Once you’ve gone through the Setup Wizard, click “next” and you’ll see a screen where you should
preview the new settings before you save them. If you need to make any changes, click “Prev”. If the
information is correct, click “Save” to save the new settings. If you don’t want to make any changes,
click “Cancel”.
You will be prompted to turn your CLEAR Spot off, and then on again, so that the new settings take
effect.
Step 1: Includes changing the administrative
password, which is defaulted to “admin”. Note: You
also can change the password in the Tools / Admin
section of the Setup tabs at any time. Step 1 also
includes setting the time zone for your location,
enabling or disabling Daylight Savings Time, and
choosing the Time Server setting. Time servers are
Internet based sites deigned to synchronize the clocks
of computers over the internet. Choosing a server
closest to your physical location is recommended but
not necessary.
Step 2: Is where you can personalize the
CLEAR Spot wi-fi network name (SSID) and
choose the security setting. The default
network name is “Clear Spot xxx” where
“xxx” are the last three digits of the MAC ID,
which can be found on the label on the
CLEAR Spot battery cover and under the
battery. It might be referred to as MAC or
Default Network. The CLEAR Spot wi-fi
network name can be 1 – 32 characters
long.
If you’re using your CLEAR Spot and are
connected to the internet, click here to
open the CLEAR Spot Home Page.