Cisco 700 - Manual (Page 89)

Terminal Communications B-3
Note The configuration port does not support hardware flow control.
Step 7 Power on the router.
Step 8 Click OK to connect. You can test the connection by pressing Enter. A
command-line interface prompt appears.
It is assumed that this is a new connection. Once it is created, you can save the Connection
Description by selecting File>Save As.
Troubleshooting the Terminal Connection
Although the balance of the Hyperterminal settings should default to the correct values, if
you have problems, select File>Properties, and check the following.
Table B-1 Hyperterminal Default Settings
Setting Location Value
Use FIFO buffers Configure>Advanced Windows should detect the
presence of the 16550 UART
chip and set this correctly by
default. If there is any doubt
about the presence of the chip,
deselect the check box.
Receive Buffer Configure>Advanced Low
Transmit Buffer Configure>Advanced Low
Function, arrow, and control
keys act as Settings Terminal Keys
Emulation Settings Auto Detect
Backscroll buffer lines Settings 500
Send line ends with line feed Settings>ASCII Setup Deselected
Echo typed characters locally Settings>ASCII Setup Deselected
Line delay Settings>ASCII Setup 0