Report paper threading, Before starting operation – Toshiba TEC EMl-31015D User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EM1-31015D
Roll stopper
Report paper
(1)
Be sure to plug the power plug into an AC outlet.
(2)
When the control lock is turned from OFF to REG position, the scale goes through the test
scanning sequence, such as 0000, 0000, 00000, then 1111, 1111, 11111 ............................. and zeros
appear on the weight and total price displays. When the control lock is turned from OFF to
REG over 16 seconds after the power plug is plugged into an AC outlet, all “8”s appear on ail
displays for a moment, then zeros appear on the displays and the scale is ready for use.
(3)
While the scale is in the test sequence, do not pul anything on the platter.
(4)
Do not move the scale while it is in operation. Should it become necessary to move it at any
time, turn the power OFF and be sure to readjust the level indicator after relocating the scale.
(5)
Should a power failure occur during operation, remove the commodity from the platter and plug
the power plug into an AC outlet again when power is restored.
(6)
If the scale is used with an unrated power source, inaccurate scaling or other errors may occur.
(7)
If the Zero Point has shifted during scaling, and no tare is displayed, adjust the Zero Point by
depressing the ZERO key.
17-