Opening the drawer, Removing the drawer – Toshiba MA-1190 User Manual
Page 94
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEANING THE VALIDATION SLIP DETECTOR
Journal
Slip Detector /
Receipt
Ribbon
Dot Head
Fig. 20
Clearn
the
validation
slip
detector
when
replacing
the
receipt,
journal
paper,
or
ink ribbon.
If
the
slip
detector
has
not
be
cleaned
for
a
long
period
of
time,
keys
may
fail
to
be
accepted
on
the
ECR.
In
such
a
case,
the
*'SLP"
lamp
will
be
kept
on.
This
is
the
same
condition
as
a
slip
has
been
inserted,
because
of
paper
dust
deposited
on
the
slip
detector.
1. Turn the Power Switch to OFF.
2.
Remove
the
Ribbon
Cover
(see
the
pevious
page),
3.
Open
the
Cutter
Block
(see
the
previous
page).
4.
The
slip
detector
is
indicated
by
the
arrow
in
Fig.
20.
If
the
dot
head
is
located
on
the
right
side
of
the
machine,
close
the
Cutter
Block
and
turn
the
power
on
and
off
again,
and
the
dot
head
will
move and stop on the left side.
5.
Clean
the
slip
detector
with
a
brush.
After
cleaning,
make
sure
that
the
Ink
Ribbon
is
properly
mounted
on
the
Ribbon
Guides. (Fig. 21)
6.
Close
the
Cutter
Cover.
(Securely
hook
the
cover
on
the
left
side;
see
the
previous
page.)
7. Turn the Power Switch to ON.
8.
Depress
[NS]
key
to
issue
a
receipt.
Check that
the
receipt is printed
normally,
9. Attach the Ribbon Cover.
OPENING THE DRAWER
The
drawer
opens
automatically
when
a
registration
is
finalized.
In
the
event
of
a
power
failure
or
a
trouble,
however,
open
the drawer in the following manner.
Insert
the
Drawer
Release
Key
into
the
Drawer
Release
Lock
and
turn
the
key
by
45
degrees clockwise (Fig. 22)
REMOVING THE DRAWER
1. Lift the drawer up and pull it out.
2.
Then
let
it
go
down
and
pull
it
out
again,
and it will be removed.
3.
When
getting
back
the
drawer,
fit
its
rollers
on
the
rails
of
the
register
and
push it all the way in, (Fig. 23)
- 90 -