Toshiba TEC MA-206 - Manual (Page 50)

E01'11002
9. READ (X) AND RESET (Z) REPORTS
The following table shows available reports and the the key operations to issue those reports. The
contents of the X and Z reports are the same if both are available, except that:
1) Symbol X for X (read) reports, and Z for Z (reset) reports are printed as the header.
2) A reset count is printed near the end of a Z report (but not on X reports).
3) All the resettable counters and totals will be reset on a Z report issuance, while they will not
be reset on an X report issuance. Therefore, X reports may be taken at any time and any
number of times during the day or at the end of the day.
TABLE OF X AND Z REPORTS
LOCK
* DAILY READ AND RESET
DAILY READ X “1
DAILY RESET (DEPARTMENT +
FINANCIAL + CLERK + GROSS PROFIT)
z
J
[AT/TL] 47
PLU READ AND RESET
ALL PLU READ X
2] [PLU]
ALL PLU RESET
z
ZONE PLU READ X
HI
PS'S?.! p'-«
ZONE PLU RESET
z
49
HOURLY RANGE READ AND RESET
HOURLY READ X “1
HOURLY RESET
z
J
10 [AT/TL] 50
* MEDIA-IN-DRAWER READ X [#/NS] 51
* GT READ AND RESET {ACCUMULATED
DAILY)
GT READ X
^ 20 [AT/TL]
GT RESET
z
52
NOTES : 1. The drawer wiff open on the depression of the final key of the KEY OPERATION
for the reports marked with “ * ” in the table.
2. Refer to the report samples on the following pages. As for the program data
reading which is also available in the “ X ” mode, see the “VERIFICATION OF
PROGRAMMED DATA“.
-46 -