Toshiba TEC MA-206 - Manual (Page 15)

E01-11002
)
CLEAR KEY ([C])
This key is used to dear a numeric entry or a declaration key {such as [RTN
MDSE] ) entry if prior to depressing a motorized key (a key to execute printing
of the entry, such as [DEPT] or media keys), or to correct any error condition
and cancel the alarm.
If the [C] key is depressed after a subtotal is once obtained, the subtotal
amount is again displayed. If the sale total plus taxes is once obtained by the
[TXBL TL] key or the [ST] key with the “Taxable Total Display” option,
depressing the [C] key there will display the sale total plus taxes.
#
#/CID
NON-ADD NUMBER PRINT ([#]),
NON-ADD NUMBER PRINT/ CASH IN DRAWER KEY
([#/CID])
This key is used to print a non-add number {such as Check No., Credit Card
No., etc.) on the receipt and journal for future reference.
To operate, enter a maximum 8-digit number (the preceding zeros will not
be printed if any entered), and then depress [#]. The number is then
printed. This operation may be performed any time between sale items,
before or after all the sale items if the sale has not been finalized yet. The
numbers thus printed will not affect the sale total.
NS
NO SALE KEY ([NS])
This key is used to open the cash drawer while the machine is outside a sale.
To operate, depress this key once. This function is usually used to break a
big bill, or to check the receipt and journal print condition.
A non-add number may usually not be entered prior to a no-sale operation
within one receipt sequence. However, it can be programmed to allow a no­
sale operation after a non-add number entry.
LC
OPEN
LISTING CAPACITY OPEN KEY ([LC OPEN])
This key is used to release the listing capacity preprogrammed on each
department. To operate, depress
[LC OPEN] before operating the depart­
ment.
By depressing the [LC OPEN] key, the HALC (High Amount Listing Capacity)
of the department will be released to allow a numeric entry with two more
digits.
-
1 1
-