Toshiba TEC DRJST-51 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

E01-13010

DRJST-51 SERIES

1) Follow Steps 1) and 2) for "Installing the

receipt roil" in the preceding section.

2) Place the paper end on the right holder so

that paper will be fed from the bottom of the

paper roll. (Fig. 1)

Installing the journal roll

3) Insert the paper end into the paper inlet

until it stops, then feed the paper by

pressing the JOURNAL FEED Switch until
the leading edge of the paper comes out
about 25 cm. (Fig. 2)

Note: When paper is inserted into the

printer for Taiwan, the paper is

automatically fed.

4) Insert the paper end into the slit on the

take-up Reel and wind it around the reel
two or three turns. (Fig.3)

Place the take-up reel on thetake-up holder.
(Fig. 4)

5) Push the take-up reel rearward until slack

in paper is eliminated.

6) Attaching the paper cover. (Refer to the

"Attaching the paper cover".)

- 8 -