Toshiba TEC MA-1300 - Manual (Page 60)

EOl-11064
12. READ (X) AND RESET (Z) REPORTS
The following table shows available reports and the the key operations to issue those reports. The
contents of the X and Z reports are the same if both are available, except that:
1) Symbol X for X (read) reports, and Z for Z (reset) reports are printed as the header.
2) A reset count is printed near the end of a Z report (but not on X reports).
3) All the resettable counters and totals will be reset on a Z report issuance, while they will not be
reset on an X report issuance. Therefore, X reports may be taken at any time and any number
of times during the day or at the end of the day.
TABLE OF X AND Z REPORTS
MODE
LOO<
...................................................... ...
* DAILY READ AND RESET
DAILY READ X
H [AT/TL] 58
DAILY RESET (DEPARTMENT +
FINANCIAL + CLERK)
Z
PLU READ AND RESET
ALL PLU READ X
H [PLU]
ALL PLU RESET Z
ZONE PLU READ X
ZONE PLU RESET z Ji isrssi
60
* CLERK READ AND RESET
With Code Entry Type: -i
1 Clerk No.l [CLERK No.l
INDIVIDUAL CLERK READ X of the
INDIVIDUAL CLERK RESET Z
required
clerk
1 [AT/TL]
62
With Clerk Lock Type:
Set the Clerk Key of the
required clerk
HOURLY RANGE READ AND RESET
HOURLY READ X
^ 10 [AT/TLJ
HOURLY RESET Z
61
* MEDIA-IN-DRAWER READ X [#] (or I#/CID1, [#/NSD 62
- 56 -