RCA 390 - Manual (Page 26)

Programming the Timer (continued)
[5]
The display will prompt you to select either
AM or PM.
NORMAL PriOGRAM
PROGRAM 1
CH 0Л
TIME ON 06 00
AM 1 PM 2
TO END PUSH PROGRAM
Press "I" for AM or "2" for PM.
[63
The display will prompt you to select the stop­
ping time.
f NORMAL PROGRAM
/ PROGRAM 1 '
' C h 04 I
TIME ON 06 00 PM I
: TIME OFF • I
TO END PUSH PROGRAM
Press four digits, two for the hour and two
more for the minute. For example, press
0 8 0 5 for 8:05. (Always press “0" before a
single-digit hour or minute.)
[7]
The display will prompt you to select either
AM or PM.
NORMAL PROGRAM^^
program 1 \
CH C4 I
TIME ON 06 00 PM I
TIME OfP 08:D5 I
PM“2
, TO END PUSH PROGRAM .
Press “1’’ for AM or “2" for PM.
[ 8 ]
The display will show ‘'START DATE" followed
■ by the current date and day.
If you want to start recording on the current
day, skip to Step 9.
^ NORMAL PROGRAM '
PROGRAM 1
C h 04
TIME ON 06 (X) PM
TIME OFF 06:05 PM
START DATE 07nflfB6
SAT
, TO END PUSH PROGRAM ,
If you want to start recording on a future date,
press four digits (two for the month and two
for the day). Press “0” first for a single-digit
month or day. For example, press 0 8 0 5 to
begin recording on August 5.
The year and day of the week are displayed
automatically when you finish.
[9]
Press PROGRAM to enter your program and
return to the original display. Additional pro­
grams may be entered by repeating steps 2-9. ' TO SELECT MODE '
PUSH NUM8E R SHOWN
1 CLOCK SET
2 NORMAL PROGRAM
3 DAILY PROGRAM
4 WEEKLY PROGRAM
5 PROGRAM REVIEW
, TO END PUSH PROGRAM /
If you have no other programs to enter, press
PROGRAM again.
[10]
Turn off the VCR.
Checking the Timer Programs--------------------------------
Programs can be checked whenever the VCR is
recording. not
1 .
3.
4.
Press PROGRAM on the remote hand unit to display
the programming menu.
Press 5 (Program Review).
The TV screen will display for ten seconds the infor­
mation you entered for the lowest program number.
Then the display changes to the next higher program
number, and so on until all program information has
been displayed.
Press 5 again if you want to view the next program
information without waiting ten seconds.
When you are finished, press PROGRAM to erase
the on-screen display.
Clearing a Timer Program--------------------------------------------
1. Press PROGRAM on the remote hand unit to display
the programming menu.
2. Press 5 (Program Review).
The TV screen wilt display for ten seconds the infor­
mation you entered for the lowest program number.
Then the display changes to the next higher program
number, and so on until all program information has
been displayed.
3. Press 5 again if you want to view the next program
information without waiting ten seconds.
4. Press CLEAR when the program information you
want to clear is displayed.
5. Press PROGRAM to erase the on-screen display.
Notes:
• Normal timer programs clear automatically when the
recording is finished, but daily and weekly programs
remain in the timer indefinitely.
• All programs are erased if power is interrupted for
more than approximately ten minutes.
24