Toshiba KV-6200A - Manual (Page 7)

A Word on the Exclusive 3N-100AAS
Battery Pack
The TOSHIBA nIckel'Cadmium battery pack (3N-100AAS) is
used for power source of the built-in clock and memory circuit.
Charging the Battery Pack__________________
1. Turn on the VCR,
2. The battery pack in the VCR is charged.
Battery Installation_________________________
Removal:
1. Remove the battery cover.
2. Disconnect the connector in the VCR.
Specification of Battery
■ Temperature
For charging
For operating
For storing
■ Charging time
Notes: -----------
O-C to 80“C
-20“C to 80-C
-30“C to eo"c
more than 48 hours
Use onEy for this VCR.
Do not dispose of the batteries into fire.
Do not short circuit the terminals.
Do not modify or disassemble.
Avoid dropping, unnecessary shocks.
Connector
^^009
Battery pack
Installation:
1. Install the battery pack, connect the connector on the
battery pack to this VCR.
Make sure the polarities {+} and (-) are correct.
2. Close the battery cover.
Note:-------------------------------------------------------------
If the Battery Pack is removed, the memory data will be
erased. In such a case, perform the setting from the first step.