Before applying power of ac adaptor, Unpacking, Iiav-12qv – Kenwood DPC-41 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Unpacking
Unpack the unit carefully and make sure that all accessories and cables are put aside so they
will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is;damaged or fails to oper
ate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping
company without delay. Only the consignee (the person or company receiving the unit) can file
a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport
or ship the unit in the future.
Before applying power of AC adaptor
Important!
USA and Canada
Unit shipped to the above are not equipped
with an AC voltage selector switch and the
discussion of such a switch that follows
should be disregarded.
All other countries
AC adaptor shipped to countries other than
the above are equipped with an AC voltage
selector switch on the top cover. Refer to
the following paragraph for the proper set
ting of this switch.
AC voltage selection
AC adaptor operates on 110—120 volts or
220 — 240 volts AC. Before connecting the'
power cord to your AC outlet, make sure that
the setting position of this switch matches your
line voltage. If not, it must be Set to your vol
tage in accordance with the following
direction.
Note:-------------------------------------------------------
Our warranty does not cover damage caused
by excessive line voltage due to improper set
ting of the AC voltage selector switch.
WARNING:
TO PREVENT FIRE OR ELECTRIC
SHOCK,
DO
NOT
EXPOSE
THIS
APPLIANCE TO RAIN OR MOISTURE.
no. .
220
240
V '
I 10
■|20
■ V
.
220
240
V
Iiav-12QV
220 V-240 V
Move switch lever to match your line voltage
with a small screwdriver or other pointed
tool.
AC voltage selector switch
Fig. 1
Before plugging in this unit, make sure
that the position of the AC Voltage
Selector conforms to your line (mains)
voltage. If not, it must be reset. See
Fig. 1.
WARNING NOTICE:
IN MOST CASES IT IS AN INFRINGEMENT
OF COPYRIGHT TO MAKE COPIES OF
TAPES OR DISCS WITHOUT THE PER
MISSION OF THE COPYRIGHT OWNERS.
ANYONE WISHING TO COPY COMMER
CIALLY AVAILABLE TAPES OR DISCS
SHOULD CONTACT THE MECHANICAL
COPYRIGHT
PROTECTION
SOCIETY
LIMITED OR THE PERFORMING RIGHTS
SOCIETY LIMITED.
DPC-41