Note on connection of optical-fiber cable, Connection of system control cord, Plugging the connector – Kenwood DM-VH7 User Manual
Page 7: System connections, System operation features
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
System connections
System connections
Make connection as shown below. When con
necting the related system components, refer
also to the instruction manuals of the related
components.
Caution: Do not plug in the power lead until all
connections are completed.
When installing this unit, reserve a clearance of at
least 10cm from the rear wall.
Malfunction of microprocessor
P If operation Is not possible or erroneous display
appears even though all connections have been
• made properly, reset the microprocessor refer
ring to
"In case of difficulty".
“02
Note on connection of optical-fiber cable
The optical-fiber cable is used in the connection of
the CD receiver (optional RD-VH7). The digital
signal transmission makes it possible to record
the high-quality sound of CDs without degrada
tion.
Connection of system control cord
Plugging the connector.
Insert the optical-fiber cable straight Into the connector
until it clicks.
Be sure to attach the protection cap when the connector
is not used.
Never bend or bundle the optical-fiber cable.
Unplugging the connector
insert the connector straight until it clicks.
While pushing the two sides of the connector, pull it
straight out.
System operation features
Easy operation function
Timer recording/playback
When this unit is connected with the CD receiver (RD-
When this unit is connected with the CD receiver (RD-
VH7) through a system control cord, the basic operations
VH7) through a system control cord, timer playback of an
of this unit can be controlled from the remote control unit
MD and timer recording of radio broadcasting are pos-
provided with the RD-VH7. This connection also makes
sible.
possible the easy operation function which activates
For details, read this instruction manual as well as the
operations according to the input selection made on the
Instruction Manual of the RD-VFI7.
RD-VH7 (two-way operations). For details, refer to the
Operations on this unit: Steps
El
to □ in
"General
Instruction Manual of the RD-VFI7.
recording." -35
• Commercial digital equipment (BS tuner, DAT, etc.)
can be connected to
"OPTICAL 2".
•'SB
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
(ISotesI 2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet.
Plugging/unplugging connection cords without removal of the power cord can cause malfunctions or damage
to the unit.