Kenwood DM-VH7 - Manual (Page 13)

Systematized recording features
When this unit is connected with the CD receiver (RD-VH7) through a system control cord, desired tracks
can be selected while playing a CD and recorded automatically onto an MD. This function is referred to
as O.T.E. (One Touch Edit). The synchronized recording with CD also possible in this configuration.
Preparation
• Connect the digital output of the CD receiver to
DIGITAL 1 input of the MD recorder. *02
• Select the CD input on the CD receiver.
• Load a recordable MD in the MD recorder. -OCj
Display when an MD is loaded
1
r 1
Recordable MD Recording-pro­
tected MD
Playback-only
MD
Recording a single CD track (O.T.E.)
Play the track to be recorded.
Press the D.T.E. key.
• When the O.T.E. key is pressed during CD playback, the
track being played will be replayed from the beginning
and only this track will be recorded.
• After the track has been recorded, the MD recorder
stops and the CD player enters pause mode.
• With O.T.E. recording, the recording input is automati­
cally set to DIN CD (digital) and the recording level is
automatically set to 0 dB.
• It is not possible to change the recording input or
recording level during O.T.E. recording.
Press the stop (■) key to stop recording in the middle.
Recording all tracks on a CD (0. T.E.)
Q Stop CD playback.
Press the D.T.E. key.
• When the O.T.E. key Is pressed while the CD player Is
in stop mode, all of the tracks of the CD will be recorded.
• After the track has been recorded, the MD recorder
stops and the CD player enters pause mode.
• With O.T.E. recording, the recording input is automati­
cally set to DIN CD (digital) and the recording level is
automatically set to 0 dB,
• It is not possible to change the recording input or
recording level during O.T.E, recording.
Press the stop (■) key to stop recording in the middle.
When this unit is connected with the CD receiver (RD-VH7) through a system control cord, recording (MD)
and playback (CD) can bestartedsimultaneously so that playback sound can be recorded without the loss
of any part.
Systematized recording features Q jj
Preparation
• Connect the digital output of the CD receiver to
DIGITAL 1 input of the MD recorder. *[=i2
• Select the CD input on the CD receiver.
• Load a recordable MD in the MD recorder.
Synchro recording with CD player
Select the REC INPUT.
Adjust the recording level.
O Play the CD to be recorded.
0 Press the MONITOR key
IVILMMI I UH
©Adjustthe recording level.
To decrease
level .
To increase
level
GD CD
Play the CD player.
Each press switches the mode.
ANALOG
DIN CD
MONO
-02
[
Select "DIN CD" for recording a digital input or "ANA­
LOG" for recording an analog input.
• The recording level can be adjusted even during record­
ing.
• Press the MONITOR key again to cancel monitoring.
Level value
MONITOR
AUTO
DIN CD
l^lllllll I
Riii
TRACK
if
Stop CD playback.
Q Put the MD recorder in record-pause mode.
f
Adjust so that these segments light at times.
• Adjust so that the segments before the vertical bars near
the right end of the level meter light occasionally.
• The initial recording level is -12 dB for analog input
recording and 0 dB for digital input recording.
• The recording level can also be adjusted using the rec
level keys on the main unit.
Press the record (•) key to enter record-pause mode
automatically.
When the CD playback starts, the MD recording starts
automatically.