Analog audio out, Equalizer settings, Reset audio mode – Vizio E320VL User Manual
Page 36: Settings menu, Tuner, Auto channel search, Partial channel search, Equalizer settings reset audio mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
VIZIO 320VL and E370VL User Manual
Analog Audio Out
This option sets the volume control properties when using the RCA (white and red)
connectors as audio line out to connect a Receiver/Amplifier/Home Theater system. Choose
from Fixed or Variable. When set to Variable, volume from the external speakers will change
according to the volume setting on the TV. If it is set to Fixed, the volume can only be
changed by the settings on the external stereo system.
Equalizer Settings
To select the options in the Equalizer sub-menu, press OK. A new menu
will be displayed showing the volumes of different frequencies.
Starting from lowest to the highest, they are 100 Hz, 300Hz, 1 kHz, 3 kHz
and 10 kHz.
1. Press ◄ or ► to select the frequency to be adjusted.
2. Use
A
or
T
to adjust the selected frequency to your
preference. Values above 0 will boost the frequency and
values below 0 will attenuate the frequency.
Note: The Equalizer adjustment will only be available when SRS TSHD is
set to Cff.
Reset Audio Mode
Return all Audio settings to factory default. A screen will come up
to confirm your selection or to cancel it. Press ◄ or ► to make the
selection, and then press CK to accept it.
Cniy settings under the Audio menu will be reset.
Settings Menu
Tuner
Note: The tuner option can only be selected when your HDTV is in TV input mode.
Tuner Mode
Select Cable or Antenna depending upon which you have attached
to the DTV / TV Input.
Auto Channel Search
Automatically search for TV channels that are available in your
area. Be sure to first select the correct tuner mode above. The TV
will search for analog and digital channels. When the search is
done, press OK to begin watching your programs.
Time
&
Local Settings
Partial Channel Search
If you believe channels are missed from the auto search, you can
do a partial channel search to look for channel in a certain channei
range again. Select to scan for Analog, Digital, or both
Analog/Digital channels, then press the
T
button to highlight the
“From” and “To” selection. Press the ► button to seiect the range
of channel numbers you want to start searching in. Press OK to
start channei search.
Tuner Menu including Channel Search,
Add, Skip and MTS Audio controls
36