Chapter 3 vizio remote control, Installing the batteries, Remote control range – Vizio E320VL User Manual
Page 15: Vizio remote control precautions, Installing the batteries remote control range, Vizic remote control precautions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

VIZIO E320VL and E370VL User Manual
Chapter 3 VIZIO Remote Control
Installing the Batteries
1
.
2
.
3.
Remove the battery cover.
Insert two AA batteries into the remote control. Make sure that
you match the (+) and (-) symbols on the batteries with the (+)
and (-) symbols inside the battery compartment.
Replace the battery cover.
Precautionary Tips for Inserting the Batteries:
....-....
•
Only use Alkaline AA batteries.
•
Do not mix new and old batteries. This may result in cracking or leakage that may cause a fire or
iead to personal injury.
•
Inserting the batteries incorrectiy may also result in cracking or leakage that may cause a fire or
iead to personal injury.
•
Dispose of batteries according to local hazardous waste regulations.
•
Keep the batteries away from children and pets.
Remote Control Range
•
Point the remote control directly at this sensor for the
best response to the remote signal.
•
Do not place any obstacles between the remote control
and the remote control sensor.
The effective range of the remote controi is
approximately 22 feet (7 meters) from the front of the
remote control sensor, 30° to the left and right, 20° up
and down.
VIZIO Remote Control Precautions
•
The remote control should be kept dry and away from heat sources. Avoid humidity.
•
If the TV responds erratically to the remote control or does not respond at all, check the batteries.
If the batteries are iow or exhausted, replace them with fresh batteries.
•
When not using the remote controi for a iong period of time, remove the batteries.
•
Do not take the batteries apart, heat them, or throw them into a fire.
•
Do not subject the remote control to undue physical stress, such as striking or dropping it.
•
Do not attempt to clean the remote control with a voiatile soivent. Wipe it with a clean, damp
cloth.
Version 2/10/2010
15