Graco SNUGRIDE 30 PD115793C User Manual

Page 36

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

2. Thread the vehicle belt through the holes on either side of the base.

3. Buckle the vehicle belt. To create a secure

installation, while pushing down on the base,
pull the free end of the lap belt or the shoulder
portion of the lap/shoulder belt to tighten ©.

After installing, CHECK that the base is not

tipping on seat as shown © ■ If it is tipping,
try installing base in another seating

location or use LATCH (if available) to

install base.

4. Check that the base is level, adjust

the foot if necessary, see page 39-40.

5. Check that belt does not move by pulling

and pushing hard on base. If belt loosens
or lengthens, repeat procedure.

6. Test base for secure installation

as described in infant restraint

“Final Safety Check” page 41.