Graco SNUGRIDE 30 PD115793C User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To Install Locking Clip with Infant

Restraint:

1. Tighten the buckled belt by

pushing down hard on the infant

restraint and pulling hard on the

shoulder belt.

2. While pushing down on infant

restraint, pinch the two straps

together behind the buckle
tongue. Unbuckle the belt

without allowing it to slip.

3. Connect lap and shoulder belts

with locking clip as shown O

and ©.

4. Rebuckle belt. Check that lap belt

does not move by pulling and

pushing hard on infant restraint.

If belt loosens or lengthens,
repeat procedure.

'/2

inch

(1 cm)

Locking clip goes here,

inch (1 cm) from the buckle