Graco Carseat User Manual

Adjustable infant restraint base

Adjustable Infant Restraint Base

See infant restraint owner’s manual for

complete installation instructions.

Base with LATCH

You must read and understand both the owner’s

manual from the infant restraint and these

instructions before using the infant restraint and

base. Keep this sheet with the instruction booklet

in the pocket of your infant restraint for reference.

This base can only be used with a Graco

Infant Restraint.

If you do not have instructions for your infant

restraint or if you have any questions about

your product, call Graco at 1-888-224-6549 or

visit our website at www.gracobaby.com.

ecline the infant restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of teps in
your infant restraint owner’s

The adjustable base is used along with the level indicator on the side of your infant restraint. To check the proper angle of
the infant restraint, first make sure the vehicle is on level ground and that the infant restraint/base is not tilted sideways on
the vehicle seat. Then check the level indicator. You must look straight on at the indicator.

If the indicator shows ONLY blue, the infant restraint is properly leveled.

If any orange is showing in the level indicator, the infant restraint is
either too upright or too reclined.

To lower the foot: pull down on the bottom of the foot to the desired

setting to adjust the recline

To raise the foot: set the base on a flat surface, push in on the fingers

on the base and push down on the base to adjust the recline

If there is still orange in the level indicator when the foot is completely

extended then place a rolled towel under the foot until ONLY blue shows.

Tighten belt through base, then reinstall infant restraint. Level indicator

should now show ONLY blue—if you still see orange, re-adjust recline

Your new infant restraint base is equipped with Graco’s recline adjustment foot, which helps to properly recline the infant
restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of the steps in your infant restraint owner’s
manual.

Storing LATCH

1. For ease of storing, extend LATCH

to its maximum length

2. Locate the storage bars on bottom of

infant restraint base

3. Fasten end of LATCH (without

adjustment belt) onto storage bar

4. Repeat Step 3 for LATCH with

adjustment belt. After fastening onto

storage bar, pull on adjustment belt to

make sure LATCH is securely fastened

5. LATCH storage should look like this

when complete

Storage bars

Underside of Base