Kenwood KR-1000B - Manual (Page 22)

Timer programmed tape playback
If your tape deck has a timer stand-by feature, the following
operation is available:
1. Connect the tape deck's AC power plug to one of the
SWITCHED outlets on the rear panel of this receiver.
2. Modify the signal flowchart for the playback of the tape
deck byu pressing the TAPE MONITOR key marked A or
B corresponding to the deck connected.
3. Turn on the power switch of the tape deck to be used for
playback.
4. Set the tape deck to stand-by with the playback mode
(follow the instructions of the deck's manual).
5. Make up the timer program with the timer keyboard of
this receiver so that the program is executed at the de­
signated time.
6. Be sure that the PRESET VOL control is adjusted to the
appropriate listening level.
Use this feature for wake up operation at any designated
time.
When clearing some of the programs in the memory
1. Press the MANUAL (MODE CHECK) key each time until
the program to be cleared is shown in the timer display.
2. Press the CLEAR key once to clear the program indicated
in the timer display.
3. Repeat the steps 1 and 2 to clear any required programs.
4. Load new programs by the same procedure described in
the example 1 on pages 14 and 15.
Note:----------------------------------------------------------------------------
You can load programs into the memory in any order you desire so
that the microcomputer arranges the programs in the sequence in
which they are to be executed.
Unattended recording
If your tape deck has a timer stand-by feature, the following
operation is possible:
1. Connect the tape deck's AC power plug to one of the
SWITCHED outlets on the rear panel of this receiver.
2. Turn on the power switch of the tape deck to be used for
recording.
3. Set the tape deck to the stand-by recording mode (follow
the instructions in the deck's manual).
4. Set up the timer program with the timer keyboard of this
receiver according to the length of tape used so that the
program is executed at the designated time and termi­
nated when the recording is complete.
5. Be sure that the PRESET VOL control is turned fully coun­
terclockwise to minimize the volume.
Unattended recording with the automatic shut-off
(AUTO-OFF) feature
The tape deck connection remains set as above, proceed as
follows:
1. Set the source to be recorded.
2. Set the tape deck in recording mode.
3. Press the AUTO-OFF key and set the shut-off time ac­
cording to the length of tape (C-60, C-90, etc.) used. For
setting the time, see pages 19 and 20.
Now, you can go out while the recording is ia progress and,
at the designated time, the power is shut off.
How to clear the timer programs and store new
ones
When clearing all timer programs from the memory
1. Press the MANUAL (MODE CHECK) key once to summon
the programs to the top of the memory.
2. Keep pressing the CLEAR key momentarily until the cur­
rent time is still displayed.
3. Load new programs in the same procedure described in
the example 1 on pages 14 and 15.
22 KR-ioooB(K)