Graco HIGH EFFICIENCY LOW PRESSURE AA2000 - Manual (Page 17)

Accessories
Use Only Genuine Grace Parts and Accessories
Air Pressure Verification Kit 224-250
For use in checking air cap pressure at various gun
inlet pressures.
Do not use the air cap for spraying.
Assemble the kit as shown in the drawing below.
Install the air cap on the gun. Turn on the air to the
gun, then actuate the gun and read the resulting air
cap pressure.
The air cap pressure reading will vary slightly,
depending on the position (rotation) of the air cap on
the gun, but with the inlet atomizing air pressure set
to a maximum of 10 psi (0.7 bar) by air regulator
110-776, the average air cap pressure will be 5.8 psi
(0.4 bar). Gauge accuracy is +/- 2% over the middle
half of the gauge scale, +/- 3% over the remainder of
the gauge scale.
Ref.
No.
Part No. Description Qty.
1 186-862 AIR CAP, tapped 1
2 224-187 GUAGE ASSEMBLY;
Includes items 2a-2e
1
2a 108-294 • CONNECTOR, tube 1
2b 054-177 •TUBE, bulk
(order by length needed) 10 in.
2c 110-552 • CONNECTOR, elbow; 1/8 npt(m) 1
2d 104-192 • COUPLING, pipe, 1/8 npt(f) 1
2e 102-730 • GAUGE, 0 to 15 psi (0 to 1 bar)
10:1 Monark Pump 217-523
950 psi (66 bar) Maximum Working Pressure
Wall Bracket 206-220
Cart 208-210
Pump Suction Hose 214-960
Pail Suction Tube 165-787
Drum Suction Tube 206-266
Grounding Clamp And Wire 222-011
12 ga, 25 ft (7.6 m) wire
Brush 101-892
For cleaning gun.
pressure range
307-947 17