Kenwood CD-323M - Manual (Page 30)

CD-323M (En)
I [Format]
System...................................... Compact disc digital audio system
Laser...............................................................Semiconductor laser
[D/A Convertors]
D/A Conversion........................................................................1 Bit
Oversampling..........................................................8 fs (352.8 kHz)
[Audio]
Frequency response.................................. 4 Hz ~ 20 kHz, ± 0.5 dB
Signal to noise ratio............................................ More than 98 dB
Dynamic range..................................................... More than 96 dB
Total harmonic distortion + noise
........................................................Less than 0.004% (at 1 kHz)
Channel separation............................. More than 92 dB (at 1 kHz)
Wow & flutter.................................................. Unmeasurable Limit
Output levei/impedance
Rxed...........................................................................2.0 V/1 kii
Digital output
Coaxial..................................................................0.5 Vp-p/75il
[General]
Power consumption............................................................... 10 W
Dimensions W: 440 mm (17-5/16")
H : 173 mm (6-13/16")
D : 479 mm (18-7/8")
Weight (Net)..............................................................7.3 kg (16.1 lb)
1, KENWOOD follows a policy of continuous advancennents in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interfer­
ence to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
“ - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- - Consult the dealer or an experienced radio / TV technician for help.
FortheU.SA.
CAUTION: r —
Use of controls or adjustments or performance of procedures other than |
those specified herein may result in hazardous radiation exposure. j
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO, HACHIOJI-SHI,
TOKYO, JAPAN
1
1
1
1
(n compliance with Federal Regulations, following are reproductions
I
of labels on, or inside the product relating to laser product safety. |
1
KENWOOD CORP. CERTIFIES THIS EQUIPMENT CON-
FORMSTODHHS REGULATIONS NO. 21 CFR 1040.10,
CHAPTER 1, SUBCHAPTER J,
1
1
1
1
L
Location: Back Panel J
KENWOOD For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below. Refer
to the model and serial numbers whenever you call upon your dealer for
information or service on this product.
Model. .Serial Number.