Specifications – Kenwood DP-2060 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Specifications
[Format I
System ....................Compact disc digital audio system
Laser................................................. Semiconductor laser
Number of channels.......................................... 2 channels
playing rotation........................ 200 rpm ~ 500 rpm (CLV)
[D/A Convertors]
D/A Conversion ............... ........................................... .1 Bit
Oversampling............................................. 8 fs (352.8 kHz)
[Audio]
Frequency response.....................8 Hz -- 20 kHz ± 1.0 dB
Signal to noise ratio............................... More than 94 dB
Dynamic range..................................... . More than 92 dB
Total harmonic distortion..................... Less than 0.005%
Channel separation................................ More than 83 dB
Wow & flutter..................................... Unmeasurable limit
Output levet/impedance
Fixed .............. .............................................. 2.0V/3.3ki2
Headphone output................ ............................ 6mW (32Q)
[General]
Power consumption...................................................... 12W
Dimensions.................................W: 440 mm (17 - 5/16")
H: 106 mm (4-3/16")
D: 310 mm (12-3/16")
Weight (Net).................................................. 3.8 kg (8.4 Ib)
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or'modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE
This equipment has been tested and found to comply with the limits for a Class В digital device, pursuant to Part 15 of the FCC Rules, These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures;
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
— Consult the dealer or an experienced radio/TV technician for help.
ОР--2060/ОР-Л060