Kenwood RC-R0905 - Manual (Page 7)

Enter the setup code.
RC-RD905 iEn}
• ExarTiDle- Press 5258 to register a LD player maae by KENWOOD.
• Tne Dackiignt flasnes once eac'" time a number is eme'ed.
• P an invalid setuo code is e'^terea tne 'emote will output one long Dlm.iv
□isregara that coae a.”id mtur'' to tne beginning of steo 4.
• If you push an invalid Key, the remote wiH exit tne setup mode
Press POWER, and check to see that the
component you want to control turns on.
POWER Q
• PLAY or TUNING/SKIP can also be used instead of POWER
• it tne cor^'iDonent ooes not react, and tnere is more thar" one setup
code, enter anotner setup coae and try again.
• It the component is already on. pressing POWER will turn it oft.
Press the ENT key to store the code you
have just input
The backlight flashes twice
ROOM B
Repeat steps 3 t o 6 for all components you
want to control.
Hold down the ENT key until the backlight
flashes twice.
ROOM B
• Tnis code replaces any previous setup codes entered rorthe respective
component.
d you have comoonents that am not remote controllable, like a recora
olaver (etc.), you wi' need to register a Non-IR code at the respective
incut. This keens the respective mput rn the remote control's cyclic list
so vou can select it using the remote control Please consult the
owner's rrianual of the components you are connecting tor information
'egardiog mmote coi^trollabiliiy. The list of Non-IR cooes is included at
the beginning of the Set up code chart. -JL
• This operation should ta
• Once registerea, the display on tne receiver shows the component
type instead of the default input name.
Example: if you register a VCR at the VIDEO 1 sacks, "VCR" appears
nsteaa of "VIDEO KSAT)"
• Botn tne default input name and the component type (¡.e., " VIDE01
'VCR' ") are shown irr the on screen display when the OSD mode is set
to ON (for 1 090VRk
• After initial setup, any VIDEO (VIDEO 1,2, 3, 4) or TV 101/1, TV2, CABLE)
inputs that nave not been program,med with a setup code or Non-IR
coae are deleted Tom the cyclic list (except for the "AV AUX" VIDEO
inputi. The PHONO input will be deleted if a Non-IR code was not
registered
• The INPUT SELECTOR on the front panel ot the receiver always cycles
through 3'i inputs
eac" setL.p coae ,s oes c'en m w
tries mav 0 "' V operate so'"^ of thr
s'umber of different models, certain coaes may not work with some moaels. (Also,
a-.-ailapie on a oiven m-odel.)