Sharp CS-2870 - Manual (Page 8)

(D
J_L
n
(§)
0
or [ h ] has been pressed in addition and subtraction.
Note: • The count is printed when the memory is recalled.
• Pressing of clears the counter.
Neutral
Note: The counter has a maximum capacity of 3 digits (up to ±999). If
the count exceeds the maximum, the counter will recount from
zero.
FIRST FACTOR ACCUMULATION SELECTOR:
Tr': The first factor is automatically added to or subtracted from the
memory. A first factor means the first number in multiplication and
division and each number is printed with "xl" and “^1" respectively.
Ex. 2 x 3 x 5 t 6 =
1 2 - 5 - 7 x 9 =
-56 X 4 X 0.5 =
Neutral
PAPER FEED KEY
B LAST DIGIT CORRECTION KEY
(Tg) ^ GRAND TOTAL KEY:
Prints and clears the “GT’ memory contents.
(13) gj NON-ADD/SUBTOTAL KEY:
Non>add - When this key is pressed right after an entry of a number in
the Print mode, the entry is printed on the left-hand side with
This key is used to print out numbers not subjects to calculation
such as code, date, etc.
Subtotal - Used to get subtotal(s) of additions and/or subtractions. When
pressed following [|] or B > ^he subtotal is printed with “0" and
the calculation may be continued.
By pressing this key even in the Non-print mode, the displayed number
is printed with “P”.
0 H TOTAL KEY:
Prints the total of addition and subtraction with ". This key also serves
as a clear key for the calculation register and resets an error condition.
0 ^ CLEAR ENTRY KEY:
Clears number entered prior to use of a function key.
Also used to clear an overflow error caused by an entry.