Sharp CS-2870 - Manual (Page 5)

OPERATING CONTROLS
® oi
^ Ofp'
p •
I I
— F
— 6
— 5
— 4
— 3
“2
I I POWER SWITCH
' ON
PRINT MODE SELECTOR:
“P": Set to the print mode.
+P" will be printed.)
Set to the non-print mode.
-P" will be printed.)
DECIMAL SELECTOR:
Presets the number of decimal places in the answer.
In the “F’ position, the answer is displayed in the floating decimal system.
©
® o=-
ROUNDING SELECTOR:
Set decimal selector to “2”.
4 -r 9 = 0.444 .... 5 -^ 9 = 0.555 ..
4 E]9[I] 5 EIsS]
T 0.45 0.56
5/4 0.44 0.56
i 0.44 0.55
Note: The decimal point floats during successive calculation by the use
of 0 or g .
If the decimal selector is set to “F” then the answer is always
rounded down (i ).
CONSTANT MODE SELECTOR:
“K”: The following constant functions will be performed:
Multiplication: The calculator will automatically remember the first
number entered (the multiplicand) and 0 instruction.
Division: The calculator will automatically remember the second
number entered (the divisor) and Q instruction.
Add-on/Discount/Mark up:
The calculator will automatically remember the first
entered number and key functions for Add-on/Dis-
count/Mark up calculation.
Neutral