Kenmore 116.32734 - Manual (Page 7)

OPERATING INSTRUCTIONS
GETTING STARTED
iiiiii .1 I .1 I .V IMP ■
§
iLl Ik I 'IMMI MF '
Turn the quick
release upper
cord hook to
either side
and down to
release the
power cord.
Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Check to be sure
the power cord is still locked into the locking
notch in the quick release upper cord hook.
Note: To reduce the risk of eieciric shock,
this vacuum cleaner has a polarized plug,
one blade is wider than the other
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician to install the
proper outlet. Do not change the plug in any
way.
Plug the polarized power cord into a 120
Volt outlet located near the floor.
WARNING
Persona! Injury and Product
M j|>M FI LJ M
I«raiiidyi7 ncic.f:3liu
• DO NOT plug in if switch is in the
ON position. Personal injury or
damage could result
• DO NOT use outlets above coun*
ters. Damage from cord to items In
surrounding area could occur.
PILE HEIGHT SELECTION AND SETTING
To select a pile height setting:
Turn off cleaner. Select a pile height setting
by tilting the cleaner back until front wheels
are lifted slightly off the floor as illustrated.
Slide the adjustment lever to the correct
setting.
SUGGESTED PILE HEIGHT SETTINGS
You may need to raise the height to make
some jobs easier, such as scatter rugs and
longer pile carpets. Suggested settings are;
HIGH: shag carpet, tong pile, plush, scatter
rugs.
MED: medium to long pile.
LOW: short to medium pile.
EX LOW: very low pile and bare floors.
Note: When the pile height selection is
set to EX LOW the pull forces will be
stronger at the agitator. If the push/pull
forces are to aggressive or Jerky a higher
setting should be used.
WARNING
Personal Injury Hazard
To avoid personal injury, DO NOT
place hands or feet underneath
the unit when changing height
setting.