Warning, Caution – Kenmore 116.32734 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REPLACING BELT
A
WARNING
Electrical Shock And Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec
trical shock or personal injury from
cleaner suddenly starting.
Replace belt whenever a burning rubber
smell caused by excessive slippage
occurs.
CAUTION
BELT AND MOTOR SHAFT
BE HOT!
Make sure the vacuum has complete
ly cooled prior to replacing belt.
To remove the belt cover, depress the tab
and lift off. Remove worn or broken belt.
Place CARPET/FLOOR selector in the
BARE FLOOR position.
Loop new belt
around the motor
shaft. Hold the
inside of the belt
against the top of
the large pulley
and rotate the
pulley clockwise
until the belt is
completely on the
pulley.
Note: See PARTS AND FEATURES for
belt number.
Rotate the pulley and the motor shaft to
ensure that belt is not twisted or pinched.
place.
DO NOT operate cleaner without belt
cover in place.
21