Assembly instructions, Warning, Handle assembly – Kenmore 116.32734 User Manual
Page 5: Cord assembly, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
A
WARNING
Electrica! Shock Hazard
Do not plug into the electrical sup
ply until the assembly is complete.
Failure to do so could result in elec
trical shock or injury.
Before assembling vacuum^ check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
Remove shipping tape from dust bin latch,
and belt cover.
HANDLE ASSEMBLY
Remove the two (2) handle screws located
in the body
Position the handle as shown in the illustra
tion below
When installing the handle, firmly press the
handle onto the body. Secure with handle
screws provided.
0
CAUTION
Do not overtighten.
Overtightening could strip the
screw holes.
Do not onerafe the f-iparipi" with
out the screws in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove
the wire tie from the power cord.
Make sure the
power cord is
placed into the lock
ing notch on the
body as shown. This
helps keep the
power cord out from
under the vacuum
cleaner agitator.
IlH
lä
Inr
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.