Kenmore 625.34859 - Manual (Page 6)

SECTION 1
WATER SOFTENER START-UP
1C. PROGRAM THE TIMER
FIG. 1
signal light adjust salt level adjust display UP button SELECT button
Kenmore Water Line
for Customer Assistance
1 - 800 - 426-9345
LOW
SALT LU
-------------- N
ON/OFF RECHARGE TONIGHT
HOLD RECHARGE NOW
>
iMJÀ
Deluxe Demand Water Softener
with Duai Segment Eiectronic Dispiay
ON/OFF-HOLD button
(Recharge Tonight-Now)
DOWN button
When the transformer is plugged in, the model code
SR31, and a test number (example: klO) show in the
face plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
□r 3
in
IS IIJ
I3,nn^
1C'LIU
PRESENT TIME
NOTES:
If SR— shows in the display, press the UP 0 or
DOWNMbutton until SR31 shows. Then, press the
SELECT button to set, and change to the flashing
PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again. if other than SR31
shows, see page 18 to reset.
SOUND “BEEPER”: A “beeper” sounds while
pressing buttons for timer set-up. One beep signals a
change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the
display reaches 1 using the DOWN button, or the
highest hardness setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words PRESENT TIME do not show in the
display, press the SELECT button (FIG. 1) until they
do, or see the previous notes.
■ Press the UP / DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
450
"
PRESENT TIME
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP /DOWN buttons changes the
time by 1 minute. Holding the buttons in changes the
time 32 minutes each second.
I I.3C'
I i>DO
PRESENT TIME