Kenmore 110. 2404# - Manual (Page 13)

How CATALYST® Cleaning Action works
1. Before agitation begins, detergent is automaticaiiy reieased
into a special chamber that mixes the detergent with a smali
amount of water to create a sudsy cieaning soiution.
2. Spinning spreads out the clothes.
3. The cleaning solution showers onto the top of the fabrics. The
soiution is puiled through the clothes, and the detergent
enzymes attach to soils and stains, iifting them away.
4. The washer fiiis to the selected water level and completes the
selected cycle.
NOTES:
■ For best results, the load should be dry at the start of the
cycle.
■ Stubborn and set-in stains might require additional
pretreatment.
Ultra Clean cycle
Use this cycle for most loads to get between 6 and 15 minutes of
wash time. For heavily soiied clothes, select the CATALYST®
Cleaning Action cycie and the Fleavy Duty speed setting.
Permanent Press I cycle
A load cooling spray rinse reduces wrinkiing. Use this 8- to
10-minute cycle for cleaning lightly to moderately soiled
permanent press blends and synthetic fabrics. Choose a siow
spin speed control setting such as Deiicate to heip reduce
wrinkiing.
Handwash cycle
Use this 4-minute cycie for hand washable garments and select
one of the Handwash Speed Select settings for the best fabric
care. The use of a detergent specialiy formuiated for the
Handwash cycle is recommended.
Whitest Whites
Use this wash cycle for loads of white fabrics that need improved
whitening. For the best soil and stain removal, select the blue
oval labeled CATALYST® on the Cycle Selector Control (Timer)
knob and the Heavy Duty setting on the Speeds seiector knob.
Bleach is recommended in this cycie to provide outstanding
whitening. Wash time is approximately 19 minutes.
Soak cycle
This cycle features agitation foilowed by soak time to help
remove heavy soils and stains that need pretreatment. The
washer wili drain when the Soak cycle ends. The Soak cycle
should be followed by an Ultra Clean or Permanent Press cycle
with additionai detergent.
NOTE: Hot water is not recommended for soaking, it may set
some stains, if using the CATALYST® Cleaning Action, use of the
SOAK cycle is not needed.
'tfl
ids 1/Ï2
This section describes the wash/spin speeds you can seiect with
the Speeds control. Each speed setting is designed for different
types of fabric and soii ievels.
DEUCATE
SLOW / SLOW
NORMAL
SLOW/FAST
HANDWASH
CASUAL •
EXI№ SLOW/SLOW
HANDWASH PLUS
FINE DELICATES
INTiRMITTENT
EXTRA SLOW/SLOW
HEAVY DUTY
FAST/FAST
HANG DRY
FAST/SLOW
Speeds Selector knob
Normal speed
This speed setting is for normaiiy soiled cottons and linens.
Setting combines siow speed agitation and fast spin speeds to
shorten drying time.
Heavy Duty speed
This speed setting is for sturdy or heaviiy soiled loads. Setting
combines fast speed agitation and fast spin speeds. For best
results, use this setting when the Cycie Selector Control (Timer)
knob is set on the CATALYST® setting.
Hang Dry speed
This speed setting is for sturdy permanent press fabrics that wiil
be line dried. Setting combines fast speed agitation and slow
spin speeds to reduce wrinkling.
Handwash Plus Fine Délicates speed
Use this speed setting for hand washabie and speciai-care items.
The wash action has repeating periods of extra-slow speed
agitation and soaking. Slow spin speeds help reduce wrinkling.
NOTE: Do not use this cycle for large items such as blankets.
Some “Hand Wash” items, particuiariy wooi, naturaily shrink
when washed. When stili wet, block these items by gentiy
stretching to original measurements. Allow the items to dry fiat.
Handwash/Casual speed
This speed setting is for iingerie and iooseiy knit items. Setting
combines extra-slow speed agitation for gentie soii removai and
siow spin speeds to reduce wrinkiing.
Delicate speed
This speed setting is for washabie knit fabrics and permanent
press fabrics. Setting combines slow speed agitation for gentie
soii removal and slow spin speeds to reduce wrinkiing.
13