beautypg.com

Recording super auto rle (ct-s450s only) – Pioneer CT-S250 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

RECORDING

SUPER AUTO RLE (CT-S450S only)

The following illustrates the operation:

(Operation completed within approximately 45 seconds)

(See page 8-SUPER AUTO BLE TUNING SYSTEM’)

OPERATION PROCEDURE

1. insert a tape for recording. (Note that a recording

cannot be made if the tab is removed.)

2. Press the SUPER AUTO BLE button.

AUTO BLE tuning takes approximately 45 second, depending on

the type of tape used in recording. The counter display shows

AUTO BLE tuning mode.

When AUTO BLE tuning is completed, the counter display

resumes previous normal counter or time counter.

The tape will be forwarded for approximately one second after

pressing the start button so that recording will start from the
recordable portion of the tape.

The operation is completed when the start position is resumed.

NOTES:
m To cancel adjusted AUTO BLE tuning, press the SUPER AUTO

BLE button again.

Make sure to readjust AUTO BLE when using different types of

tapes.

m During AUTO BLE tuning, the Dolby NR circuit will not work.

Therefore, the position of the Dolby NR button may be set to

off, B, C or S.

To cancel AUTO BLE tuning (e.g. must record urgently), press

the stop Im) button.

Error dispiay

If the old tape, the tape end or the leader (white portion)

immediately prior to the tape end is reached during AUTO BLE

operation, tuning becomes impossible. That means recording
will stop immediately and the counter indicator will display the
following (flashing) message: "Err".

In this case, press the SUPER AUTO BLE button again to reset,

and record without AUTO BLE tuning.

SUPER AUTO BLE button does not perform tuning during REC,
REC/PAUSE or REC MUTE modes.

Display

Counter indicator

START

ri n n n

u u u u

(Normal counter)

©

• Adjusting recording bias.

II

1

o c

±11 1 1 -1

®

• Adjusting recording level

(sensitivity).

1 0 1^1

l_ /_ 1' 1-

• Adjusting recording

equalizer.

c n

/_ LN|

STOP

END

n n n n

u u u u

(Return to normal counter)

12

En