Kenmore 122.1643101 - Manual (Page 11)

7. Front Trim Panel Assembly
a) . Place Front Trim Panel (W) against right side of
Charcoal Bin Front Panel. Fit Trim Panel hinge pin into hole
onto bottom of Bin Front Panel. Tab at top of Trim Panel
goes against back surface of Bin Front Panel. Holding Trim
Panel and Bin Front Panel together, slide hole on bottom
left side of Bin Front Panel onto hinge pin of Left Front Cart
Leg. Align two holes on bottom right of Bin Front Panel with
holes on Cart Bottom Panel (J). Secure Bin Front Panel to
Bottom Panel with 2 AA Round Head Screws and 2 BB
Lock Washers. See Fig. 13.
b) . Attach Front Trim Panel (W) to Front Panel (O) with 3
AA Round Head Screws and 3 BB Lock Washers. Attach
Front Panel.
c) Attach Front Panel (O) to Right Front Cart Leg (E) with 3
AA Round Head Screws and 3 BB Lock Washers. See Fig.
13.
8. Cart Beam, Front Assembly
a) . Use 4 AA Round Head Screws and 4 BB Lock Washers
to connect Cart Beam, Front (X) to Cart Leg, Front Left (B)
and Cart Leg, Front Right (E). See Fig. 14.
b) . Use 5 AA Round Head Screws and 5 BB Lock Washers
to connect Cart Beam, Front (X) bottom surface to Front
Panel (O) and Front Trim Panel (W). See Fig. 14.
Note: Attach Cart Beam,
exterior.
Front so that flat side faces to cart
9. Charcoal Bin Slide Assembly
a) . Pull and hold Charcoal Bin Front Panel forward, and
insert the two Charcoal Bin Slides (Y) through the holes in
the Front Trim Panel (W) and Left Front Cart Leg (B). See
Fig. 15.
b) . Use 2 KK Stage Screws to connect the loop hole ends
of the Slides to the Charcoal Bin Front Panel. See Fig. 15.
11