Ped] master pedestal, Set] setup level, Shp] sharpness – Canon XH A1 User Manual
Page 73: Hdf] horizontal detail frequency, Dhv] horizontal/vertical detail balance, Cor] coring, Nr1] noise reduction 1, Nr2] noise reduction 2, Cmx] color matrix, Cgn] color gain

73
Cu
st
o
m
iz
at
io
n
E
[PED] Master Pedestal
Adjust the master pedestal level in the range -9 to +9.
[SET] Setup Level
Adjust the setup level in the range -9 to +9.
• Depending on the value set for the master pedestal [PED], the setup level may not be able to take a
negative value. In that case, adjusting the setup value within a certain value range will have no effect.
[SHP] Sharpness
Adjust the sharpness level in the range -9 to +9.
[HDF] Horizontal Detail Frequency
You can select from [HIGH], [MIDDLE] or [LOW].
[DHV] Horizontal/Vertical Detail Balance
Adjust the horizontal/vertical detail balance in the range -9 (only horizontal) to +9 (only vertical).
[COR] Coring
Adjust the detail noise level in the range -9 to +9.
[NR1] Noise Reduction 1
You can select from [OFF], [HIGH], [MIDDLE] or [LOW].
• [HIGH], [MIDDLE] or [LOW]: Moving subjects may leave a trailing afterimage.
• When picture noise is already low due to the gain settings, the noise reduction function may not be
noticeable.
[NR2] Noise Reduction 2
Results in an effect similar to applying the skin detail function over the whole picture.
You can select from
[OFF], [HIGH], [MIDDLE] or [LOW].
• Unlike with the NR1 setting, a trailing afterimage will not appear.
[CMX] Color Matrix
You can select from [NORMAL], [CINE1] or [CINE2].
[CGN] Color Gain
Adjust the color saturation level in the range -50 to +50.