Canon XH A1 - Manual (Page 98)

98
Returning to a Pre-marked Position
If you wish to return to a particular scene later, mark the point with the zero set memory, and the tape will
stop at that point when you rewind/fast forward the tape.
This function is operated with the wireless controller.
1. During playback, press the ZERO SET MEMORY button at the point you wish to return
to later.
• The tape counter is reset to 0:00:00 and the mark appears.
• To cancel, press the ZERO SET MEMORY button again.
2. After you finish playing back the tape, stop and rewind it.
• If the tape counter shows a negative value, fast forward the tape instead.
• The tape stops automatically at “0:00:00” and the
mark disappears.
• The tape counter changes to time code.
 The zero set memory may not function correctly if the time code has not been recorded
consecutively.
 The zero set memory function may not work correctly if you mix recordings in HDV and DV
standards on the same tape.
REW button
ZERO SET MEMORY
button
STOP button