Cleaning method, A warning – Kenmore 122.166489 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Pull out the light bulb and replace with a new
bulb as Picture F, then tighten the four screws
which were loosen in picture E.
Note: Do not touch the halogen bulb with bare hands.
Picture F
8. Replace glass cover, reinsert light bulb housing into
the grill, and insert and tighten all the screws. Picture G.
Picture G
9. Attach original lamp rear cover with original 8pcs
screws and washers to back panel of firebox and
tighten screws as Picture H.
Picture H
Cleaning Method
Follow steps 1 through 4 above for glass cover removal. Use a damp towel to clean the surface of the
glass cover. Make sure the glass cover is completely dry before re-installing.
A
WARNING
Make sure the light switch is in the “OFF” position and the power plug is disconnected from the
power outlet prior to cleaning the glass cover.
A
warning
The glass cover should not be in contact with water or any other liquid when it's warm. Sudden
change of temperature may cause cracks in the glass.
A
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
If you still have questions about replacing bulb, call the Customer Service Helpline 8 AM - 5 PM
PST, Monday through Friday at 1-800-913-8999.
13