To empty the solution tank, Attachments, Upholstery nozzle – Kenmore 175.869039 User Manual

Page 8: Floor tools, Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

TO EMPTY THE SOLUTION TANK

See Figure 11

When cleaning is completed, both the Recovery Tank and the
Solution Tank should be emptied prior to storage. Empty the
Recovery Tank as described earlier. There are three methods
of emptying the Solution Tank.
Method 1:

1. Disconnect Short Cord from Recovery Tank.
2. Remove Recovery Tank from Solution Tank and pour

solution out of the Filler Opening.

Method 2:
1. Place Floor Nozzle in bath tub or container.

2. Depress Solution Release Trigger and spray until empty.
Method 3:
1. Remove Floor Nozzle and insert Wand into Solution

Tank through the Filler Opening.

2. Vacuum solution out.
3. All solution is now in Recovery Tank. Empty Recovery

Tank as described earlier.

ATTACHMENTS

UPHOLSTERY NOZZLE

See Figure 12

Cleanmore Carpet Oeaner Upholstery Nozzle is an attach
ment for furniture upholstery cleaning. The upholstery
nozzle may also be used to dean auto upholstery or carpet
ing. In addition, the nozzle may be used to dean carpeted
stairs and other areas difficult to clean with the normal floor
nozzle.

FLOOR TOOLS

See Figure 13

The Bare Floor/Carpet Brush (1) may be used on floors
without carpet for DRY deaning with paper dust bag in
stalled.
The Sque^ee Attachment (2) is useful for WET pickup.

CA U Ti0N :I30

NOT run the Pump Motor when using these

attachments. To prevent Pump Motor from operating, make
sure Pump Motor Switch is in "OFF” position, or unplug the
Short Cord from the Solution Tank to the Recovery Tank.