Trouble shooting, Possible solutions – Kenmore 175.869039 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE SHOOTING
PROBLEM
POSSIBLE SOLUTIONS"
1, Neither vcicuum mol or nor pump motor
runs.
1. Be sure power switch is in "ON" position.
2. Be sure power cord is plugged in secureiy,
3. Check wall electrical outlet (by plugging ¡ri
q
known
working electrical appliance). ""
2, Vacuum motor runs, but there is no
spray at Ihe nozzle.
1. Be sure Short Cord from Power Head to Solution lank is
securely plugged into receptacle oir the Power Head,
2. Check that Solution Tank is full
3. Be sure Pump Switch is in the "Hr or "LO' posiiicn
4. Nozzle Ports may be clogged. See illustration
below to
unclog.
3. Spray from The floor nozzle does not
come out evenly.
1, Unclog the Nozzle Port, See illustration below.
4. Motor runs but cleaner does not pick up
solution from carpet (no exhaust from
top of cleaner).
1. Recovery Tank is full of dirty water and must be emptied, f
2. Check for clogged hose or nozzle. Clogs could result from |
picking up material such os corpet strings, shoe laces, etx
I
5 Spray connections ieok.
' ....................... ............... ....... .....
1, Disassemble nut at leaking connection. Be sure wcsix-M' e
properly seated. Reassemble and lichTen secuffsly
• tf the 'Possible Solut ions' to "Problems' listed in the chart do not correct the problem, take your cleantjr to a Seors
Service Center for professional service. Repairs not listed in this chart require professionat and specific knowiedge
of this mod^ cleaner and could result in scrfety hazards and personal inlury If not rtrade by a qualified Sears Service
Technician.
TO UNCLOG NOZZLE PORT
See Figure 18
1. Insert the poiirt of a needle or pin into Spray Port to
unclog.
NOTE: Do not let the point of needle or pin touch any
part of the Spray Pad surface or Spray Pad will not
spray solution properly.