Kenmore 175.869039 - Manual (Page 4)

ASSEMBLY
ASSEMBLY OF RECOVERY TANK
AND SOLUTION TANK
See Figure 2
1 .
2
.
Place Recovery Tank into Solution Tank (align the word
"VACUUM" on Recovery Tank with "VACUUM" on
Solution Tank) and secure with Metal Latch.
Insert the plug on tíre Short Cord from the Solution Tank
into the Recovery Tank Power Head.
ASSEMBLY OF HOSE, WANDS,
NOZZLE AND SOLUTION TUBING
See Figure 1
1. Assemble the two Straight Wands.
2. Assemble the upper Straight Wand to the Angled Wand
of the Hose.
3. Assemble the Floor Nozzle to the lower Straight Wand.
NOTE: Be sure locking button engages properly when
assembling straight wands, angled wand, and floor
nozzle.
4. Push the Solution Tube Quick-DisconnectNutonto Trig­
ger Valve. Twist clockwise to lock. See D ETAIL “A" -
Figures,
5. Push Solution Tube into Retaining Clips on Wands. Tub­
ing may be wrapped around Wands to take up excess
slack.
'
6. Attach the Vacuum Hose to Recovery Tank inlet
(Vacuum Inlet).
7. Push solution tube quick disconnect nut onto the quick
disconnect valve. Turn clockwise so valve posts lock into
notches in nut.
See D ETAIL "B " - Figure 3.
N O TE : To rem ove m etal retaining clips from hose and solution
tube, squeeze tube with fingers before rem oving. C lips m U dislodge
easily. Also squeeze tube before reattaching clips to prevent hm e
punctures.
SOLUTION TUBE QUICK
DISCONNECT NUT
QUICK DISCONNECT
VALVE