beautypg.com

Operation, Test for solution spray, Cleaning the carpet – Kenmore 175.869039 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPERATION

TEST FOR SOLUTION SPRAY

See Figure 6

1. Hold Floor Nozzle above floor level.

2.

Pull Solution Release Trigger on Angled Wand.

D epress

Sdution

R elaiseTriggerfor30-& )seconds

until

solution begins

to

flow.

3. Observe Floor Nozzle to make sure cleaning solu­

tion is being sprayed evenly,

(see D ETA IL "A " )

NOTE: If solution is not being sprayed evenly, refer
Trouble Shooting Chart.

CLEANING THE CARPET

See Figures 7 & 8

Solution Dispensing Stroke:

1. Start at a comer (recommended).

2. Place Floor Nozzle so Suction Inlets are flush with

carpet.

3.

While exerting light pressure down on Floor

Nozzle, depress Solution Release trigger and slowly
pull Floor Nozzle towards you.

D epress Sdution R e~

letse Trigger for 30-60 seconds until sdution begins to

flow.

NOTE: Do not overwet. If three or more cleaning strokes
are required, let diy and then repeat cleaning process.

Solution Recovery Stroke:

1. Release Solution Release Trigger.

2. Lift Floor Nozzle off carpet.

3. Return Floor Nozzle to point where you dispensed

cleaning solution and pull across carpet, recovering
dirty solution.

r

LIFT.
SET FORWARD,
PULL BACK ACROSS CARPET

o