beautypg.com

When to empty recovery tank, To empty recovery tank, Operation – Kenmore 175.869039 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPERATION

WHEN TO EMPTY RECOVERY TANK

See

Figure 9

During normal operation, your cleaner may stop recovering
solution from your carpet. When this occurs there are three
check points to alert you:

1. An increase in motor noise.

2. No solution visibly being recovered by the floor nozzle.
3. No air coming from the exhaust port of your cleaner.

When this occurs;

1. The Recovery Tank is full and flte Float Valve in the

Recovery Tank has been activated. The Recovery Tank
should be emptied.

— or —

2. The Recovery Tank has foam in the Tank and the Float

Valve has been activated.

NOTE: If cleaner is acddently turned over while in operation,
the float may activate and shut off the suction. If this occurs,
set the cleaner upright. Turn Power Switch "OFF' and let
motor con>e to a complete stop. Then turn switch back on and
continue cleaning.

TO EMPTY RECOVERY TANK

See Figure 10

2

.

3.

5.

6

.

7.

8.

9.

Turn Power Switch "OFF" and Disconnect Power Cord

from Electrical Outlet.
Disconnect Short Cord located between Solution Tank

and Recovery Tank.
Disconnect Vacuum Hose by depressing the Lock Button

and remove.
Twist Solution Tube Quick Disconnect Nut counterclock­
wise; lift and remove from Quick Disconnect Valve (See

DETAIL "A").
lift Latches on Power Head.
lift power Head, by Handle, and remove from Recovery

Tank.
Rotate Meta! Latch on the Solution Taiik and lift Recovery

Tank from ihe Solution Tank.
Empty Recovery Tank.
Reassemble cleaner and resume cleaning. NOTE: Power

Head is designed to go on in only one position. Make sure
the word "VACUUM" on the Power Head is lined up
directly over tl№ Hose Inlet on Recovery Tank as shown in
Hg. 10 or Power Head will not seal to unit properly.

RECOVERY

TANK

Q U I C K

D I S C O N N E C T

N U T

QUICK

DISCONNECT

VALVE

RECOVERY

TANK

DETAIL "A"

SOLUTION

TUBING

POWER HEAD

HANDLE

ALIGN

"VACUUM*

OVER

HOSE

INLET

SHORT

CORD

UTCH

SOLUTION

TANK