Carpet preparation, Filling cleaner with water and cleaning solution, Power cord and switch – Kenmore 175.869039 User Manual

Page 5: Pump switch, Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

CARPET PREPARATION

For best results prepare carpet for cleaning as follows:

1. Vacuum carpet to remove loose dirt before using Cleaner.
2. To remove stains and ground in dirt present in heavy traffic

areas of the carpet, spray or rub Sears Heavy Traffic Pre
Treatment (82833) into carpet before using Qeaner. Follow
directions on the bottle.

FILLING CLEANER WITH WATER AND

CLEANING SOLUTION

See Figure

1. Open lid of the Filler Opening.

2. Add Sears All In One Carpet Cleaner (82813) solution or

Sears Upholstery Qeaner (82843) solution to Solution Tank
(depending on type of cleaning to be performed). Follow

directions on label of bottle,

3. Pour clean, hot water (from tap) into Filler Opening in the

Solution Tank — use two (2) gallons of water.

4. Close Filler Opening.

NOTE: This unit may become damaged if boiling water is used.

POWER CORD AND SWITCH

See Figure 5

1. Make sure Short Cord is plugged in as shown.

2. Plug Power Cord into electrical outlet.
3. Turn Power Switch to "ON" position.

PUMP SWITCH

See Figure 5

1. Place Pump Switch from "OFF" position to either "HI" or

"LO" position.

NOTE: "HI" pump speed is used for normal cleaning. "LO"
pump speed is used for delicate upholstery or light cleaning.

FILLER

OPENING

SOLUTION

TANK