beautypg.com

Problem possible cause – Kenmore 146.1615311 User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Troubleshooting - Electronic Ignition

Problem

Possible Cause

SECTION 1

• Baffery not installed

• Check battery orientation.

• Insfall baffery (make sure thaf "+" and

No sparks appear at

properly.

connecfors are oriented correctly, with "+" end

any electrodes when

control knob turned

• Dead battery.

• Has battery been used

up and end down.)

to HI: no noise can

previously?

• Replace battery with new AAA-size alkaline

be heard from spark

module.

• Button assembly not

• Check to insure threads are

battery.

installed properly.

properly engaged. Button

• Unscrew button cap assembly and reinstall.

should travel up and down

making sure threads are aligned and engaged

without binding.

fully.

• Faulty spark module.

• If no sparks are generafed

with new battery and good

wire connections, module is

faulty.

• Replace spark module assembly.

SECTION II

No sparks appear at

any electrodes when

control knob turned

to HI; noise can be

heard from spark

module.

• Output lead

connections not

connected.

• Are output connections

on and tight?

• Remove and reconnecf all outpuf

connecfions af module and elecfrodes.

SECTION III

• Output lead

• Are output connections on

• Remove and reconnecf all output connections

Sparks are present

connections not

and tight?

at module and electrodes.

but not at all

connected.

electrodes and/or

not at full sfrengfh

• Electrical arc

• If possible, observe grill in

• If sparks are observed other than from

between output wires

Dark locafion.Operafe

burner(s), wire insulafion may be damaged.

and grill frame.

ignifion sysfem and look for

arcing between output

wires and grill frame.

Replace wires.

• Weak baffery.

• All sparks present but

• Replace baffery with a new AAA-size

weak or at slow rate.

alkaline battery.

• Elecfrodes are wet.

• Has moisture accumulated

• Use paper towel to remove moisture.

on electrode and/or in

burner ports?

• Electrodes cracked or

Broken; sparks appear

• Inspect electrodes for

• Replace cracked or broken electrodes.

where cracked.

cracks.

28 « 16153- 50300312