Kenmore 146.1615311 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sideburner
□
Loosen side burner in side shelf. (B). To loosen, unscrew and remove two front screws and
washers holding sideburner in place. (A).Note: Do not loosen electrode screw.
□
Remove knob and bezel from sideburner control valve. To remove, pull knob straight out from
valve stem. Unscrew bezel from valve face and set the two screws aside.
□
Insert valve stem through hole in fascia. (C). Attach bezel to fascia and valve face with
previously removed 2 screws. (D)
□
Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (E)
□
Reattach sideburner to sideburner shelf with the 2 previously removed screws and washers.
□
Push control knob onto sideburner valve stem. (F)
□
Replace sideburner grate. (G)
□
Connect both igniter wires to the igniter module on the inside of the right fascia. To connect,
push igniter wire tips onto pins in igniter module. (H)
□
Unscrew igniter cap from control panel. Insert (1) AAA battery (not provided) into battery slot
with positive end (+) facing outward. Screw igniter cap back onto panel. (I)
im
16153- 50300312 « 23