Kenmore ASPIRADORA 116.31591 - Manual (Page 9)

PILE HEIGHT SELECTION AND SETTINGS
To select a pile height setting:
Select a pile height setting by turning the
HEIGHT ADJUST knob located on the
nozzle.
Attention: Refer to your carpet
manufacturer’s cleaning
recommendations. Some more delicate
carpets may require that they be
vacuumed with the agitator turned off to
prevent carpet damage.
Height
Knob
SUGGESTED PILE HEIGHT SETTINGS:
There are five (5) pile height settings on
the vacuum cleaner. You may need to
raise the height to make some jobs easier,
such as scatter rugs and some deep pile
carpets, and to prevent the vacuum
cleaner from shutting off.
NOTE: The nozzle will not engage into the
selected position until the vacuum cleaner
handle is lowered to the operating position.
FLOOR/TOOLS SELECTOR VALVE - FLOOR POSITION
When vacuuming floors, verify that the
Floor/Tools Selector Valve is in the Floor
position as shown in figure 1
.
RELEASING THE HANDLE
Release the handle by pressing down on
the handle release pedal with your foot
and pulling back and down on the handle
with your hand.