Troubleshooting, A warning – Kenmore ASPIRADORA 116.31591 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
Review this table to find do-it-yourself solutions for minor performance problems. Any service
needed, other than maintenance described in this Use & Care Guide, should be performed
by a Sears or other qualified service agent.
A WARNING
Disconnect electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Vacuum cleaner
won’t run.
1. Unplugged at wall outlet.
2.
Tripped circuit breaker/blown
fuse at household service panel.
3. Thermal protector tripped.
4. Defective wall outlet.
5. Handle screw not tight.
1. Plug in firmly and push ON/OFF
button.
2. Reset circuit breaker or replace
fuse.
3. Allow vacuum cleaner to cool,
then reset thermal protector.
4. Check with a good
appliance/lamp, have properly
serviced.
5. Tighten screw.
Poor job of
dirt
pick-up.
1. Full or clogged dust bin.
2. Floor tool selector valve,
not in correct position.
3. Wrong pile height
setting.
4. Worn agitator.
5.
Clogged nozzle or bag holder.
6.
Clogged hose.
7. Broken/misplaced belt.
8.
Hose not inserted fully.
9. Motor protection system
activated.
10. Dirty filters.
1. Empty dust bin.
2. Change to correct position.
3. Adjust setting.
4. Replace agitator.
5.
Check CLOG REMOVAL.
6.
Check for clogs.
7 Replace/fix belt.
8. Insert hose fully.
9. Check for clogs.
10. Clean or replace as applicable.
Vacuum Cleaner
picks
up moveable rugs or
pushes too hard.
1. Wrong pile
height
setting.
1. Adjust setting.
Agitator does not turn.
1. Broken belt
2. Thermal protector tripped.
1. Replace belt.
2. Allow vacuum cleaner to cool
40 -
50
minutes
Airflow restricted
with attachment use.
Sound changes.
1. Attachment use restricts air flow.
2. New carpet fuzz clogged air path.
1. Check attachments for fuzz,
lint, pet hair or other debris.
2. Check CLOG REMOVAL and
clean hose.
Difficulty adjusting pile
height setting
1. Vacuum cleaner not in proper
upright position.
1. Place vacuum cleaner in the
locked upright position.
Pet Handi
Mate™
will not run when
attached.
1. Carpet pile or strings entangled
2. Worn or broken belt.
1. Clean agitator.
2. Not a serviceable item, return to
Sears store or service center for
replacement if under warranty.
Pet
Handi
Mate™ does
poor job of dirt
pick-up.
1. Carpet pile or strings entangled
2. Worn or broken belt.
1. Clean agitator.
2. Not a serviceable item, return to
Sears store or service center for
replacement if under warranty.
-
25
-