Nozzle care, Belt and agitator changing, Nozzle care belt and agitator changing a warning – Kenmore ASPIRADORA 116.31591 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

NOZZLE CARE

BELT AND AGITATOR CHANGING

A WARNING

Always unplug power cord from
electrical outlet before performing any
service on vacuum cleaner.

1. Turn off and unplug vacuum cleaner.

2. With vacuum cleaner upside down,

remove four (4) screws.

3. Remove nozzle
cover by placing
vacuum in upright

position. Grasp rear

of cover and

rotate forward.

Pull up to

release.

Tabs

4. Remove agitator by carefully lifting
out.

5. Remove and replace worn or broken

belt. (Refer to
Replacement Parts

on page 5.)

6. Loop new belt
around motor
shaft and
agitator belt
groove.

7. Reinstall

agitator back

into nozzle by
pulling toward

front of

nozzle and

sliding into
grooves.

After reinstalling agitator, turn it by

hand to make sure that belt is not twisted

or pinched and that all rotating parts turn
freely.

9. Replace cover

by sliding 3 tabs

into place and
rotating closed.

Tabs